![]() ![]() Verify that you have four consecutive port NOTE The system uses four consecutive port numbers, starting with the configured portįor the remote packet capture sessions. To initiateĪdditional remote capture sessions, repeat the Wireshark configuration steps noĬonfiguration needs to be done on the WAP device. You must start a separate Wireshark session for each interface. You can trace up to four interfaces on the WAP device at the same time. To initiate a remote capture on a WAP device: ![]() Must also be configured to allow the Wireshark computer to initiate a TCP Traffic for these ports must be allowed to pass through the firewall. If a firewall is installed between the Wireshark computer and the WAP device, the When remote capture mode is in use, the WAP device does not store any captured The remote packet capture facility is a standardįeature of the Wireshark tool for Windows. Wireshark is an open source tool and is available for free it can beĪ Microsoft Windows computer running the Wireshark tool allows you to display, WAP device and sends the captured packets through a TCP connection to the Wireshark network analyzer tool for Windows. This feature works in conjunction with the ![]() The Remote Packet Capture feature enables you to specify a remote port as theĭestination for packet captures. NOTE To stop a packet file capture, click Stop Capture.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |